2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 36)

36
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to set the baud rate to 115,200 bps.
at^scport2="baudrate",230400
Enter the command to set the baud rate to 230,400 bps.
The baud rate can be set to 110 – 230,400 in standard steps.
at^scport2="data_bits",8
Enter the command to set the data bits to 8. Setting options: 5-8.
at^scport2="stop_bits",2
Enter the command to set the stop bits to 2. Setting options: 1-2.
at^scport2="parity",2
Enter the command to set the parity check type. Setting options: 0-4.
at^scport2="save"
Enter the command to save the changes.
at^scport2="restart"
Enter the command to restart the port.
at^scport2="srestart"
Enter the command to save the changes and restart the interface .
at^scport2?
Enter the command to display the currently set port values.
^SCPORT2: "BAUDRATE",9600
^SCPORT2: "DATA_BITS",8
^SCPORT2: "STOP_BITS",1
^SCPORT2: "PARITY",0
at^scport2=?
Enter the command to display the port setting options.
Relay Outputs
These commands are used for relay output control.
at^screl1?
Enter the command to identify the status of relay 1.
at^screl1=0