2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 83
83
Caution
Important! A default user with the Administrator login was created
during the
Server installation to make it possible to
2N SmartCOM
®
connect to the server and configure all the other users. The default
user login data are as follows:
Username:Admin
Password: 2n
If you use one and the same PC for the
Control Panel and the
2N SmartCOM
®
2N
®
Server, you can enter the local loop address 127.0.0.1 or the local host
SmartCOM
text as the server address. To log in to another server, enter the local or public IP
address. Or, use the DNS names if you use DNS. Enter the listening port into the
i
Port
tem as selected during your
Server installation. Contact you network
2N SmartCOM
®
administrator for correct settings.
Figure: Sign–In Window
The encryption settings are in the right-hand bottom corner. Click on Change
encryption key to display the encryption setting window. If the server requires so,
enable packet encryption and set the key. Enter the key either in the ASCII format,
where HEX is completed automatically with the translated characters, or enter the