2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 34)

34
2N TELEKOMUNIKACE a.s., www.2n.cz
®
This command displays the currently set interface values.
^SCCFG: "MODE",1
^SCCFG: "GPRS_APN","publicip.t-mobile.cz"
^SCCFG: "GPRS_USER","internet"
^SCCFG: "GPRS_PASS","hfsdj515d"
^SCCFG: "LOCAL_IP","89.24.3.195"
^SCCFG: "SIM_PIN","1234"
^SCCFG: "AUTH_IP",0
at^sccfg=?
This command displays the port value setting options.
^SCCFG: "MODE",1-3
^SCCFG: "GPRS_APN","32"
^SCCFG: "GPRS_USER","32"
^SCCFG: "GPRS_PASS","32"
^SCCFG: "LOCAL_IP"
^SCCFG: "SIM_PIN","16"
^SCCFG: "AUTH_IP,0-1
^SCCFG: "SAVE"
^SCCFG: "RESTART"
^SCCFG: "SRESTART"
Port 1 (RS 232) SC Commands
These commands are used for setting the RS 232 parameters.
at^scport1="baudrate",9600
Enter the command to set the baud rate to 9,600 bps.
at^scport1="baudrate",115200
Enter the command to set the baud rate to 115,200 bps.
at^scport1="baudrate",230400
Enter the command to set the baud rate to 230 400bps.
The baud rate can be set to 110 – 230,400 in standard steps.
at^scport1="data_bits",8
Enter the command to set the data bits to 8. Setting options: 5-8.
at^scport1="stop_bits",2
Enter the command to set the stop bits to 2. Setting options: 1-2.
at^scport1="parity",2
Enter the command to set the parity check type. Setting options: 0-4.