2N M2M Solution 2N SmartCom - User Manual 1.9.0 User Manual
Page 68
68
Figure: Communication Settings
Having selected a port, set the communication parameters to adjust communication
rates and signal transmission parameters for the serial port. The
fact
2N SmartCOM
®
ory values are set here by default. Refer to the
figure
Communication Settings
above.
No password is requested by default for the RS-232 port and so nothing has to be filled
in. Passwords may be different for different terminals. If a password is requested, enter
the password into the dialogue window displayed during the connecting process. The
last main toolbar button helps you
from the terminal connected -
Load configuration
the application gets connected and reads out all relevant data.
Tip
The application connects to the selected terminal, identifies the
RS-232 mode (DATA or COMMAND), switches the port as necessary,
reads out the data, switches the port into the original mode and
terminates communication. This gives the other users continuous
access to the terminal.
The
section displays the most important information on the given device.
State
The IP address, serial number, firmware version, logged-in provider and signal level
are displayed. The SIM ICCID (Integrated Circuit Card ID) is displayed, which is not the