2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 48)

48
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to display the GSM provider to which is 2N SmartCOM
®
currently logged in.
at^scms?
This command specifies the GSM module.
WISMO228
WAVECOM MODEM
L23_00gg.WISMO228 140711
at^iccid?
Enter the command to display the SIM ICCI (Integrated Circuit Card IDentifier).
at^scpras?
Enter the command to display the remaining PIN entering attempts.
at^sig?
Enter the command to display signal intensity in dBm.
^SIG: -65dBm (STRONG)
at^scerr?
Enter the command to write out the error buffer status.
^SCERR: 72> 8,10
^SCERR: 73> 8,10
at^scerrclear
Enter the command to delete the error buffer contents.
Charger (for 2N SmartCOM PRO Only)
®
These commands are implemented in the charger-containing ve 2N SmartCOM PRO
®
rsion only.
at^scchg="max_voltage",6800
Enter the command to set the maximum accumulator voltage in mV.
at^scchg="max_current",350
Enter the command to set maximum charging current in mA.
at^scchg="state"