2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 37)

37
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to open relay 1.
at^screl1=0,0
Enter the command to open relay 1. The relay will be open after the terminal
restart.
at^screl1=0,1
Enter the command to open relay 1. The relay will be closed after the terminal
restart.
at^screl1=0,2
Enter the command to open relay 1. The relay will be in the position as before
restart after the terminal restart.
at^screl1=1
Enter the command to close relay 1.
at^screl1=1,0
Enter the command to close relay 1. The relay will be open after the terminal
restart.
at^screl1=1,1
Enter the command to close relay 1. The relay will be closed after the terminal
restart.
at^screl1=1,2
Enter the command to close relay 1. The relay will be in the position as before
restart after the terminal restart.
at^screl2?
Enter the command to identify the status of relay 2.
at^screl2=0
Enter the command to change the status of relay 2.
at^screl2=0,0
Enter the command to change the status of relay 2. The relay will be in this
position after restart.
at^screl2=0,1
Enter the command to change the status of relay 2. The relay will be in the
opposite position after restart.
at^screl2=0,2