2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 108)

108
2N TELEKOMUNIKACE a.s., www.2n.cz
®
8.1 AT API Description
The AT API is launched on the Server and requires a licence. You 2N SmartCOM
®
have to enable its use in the Control Panel. Refer to the figure below 2N SmartCOM
®
for the basic function.
Figure: AT API
AT API Use
Having logged in, get connected via Telnet to the Server address on 2N SmartCOM
®
the port selected for the AT API. After connection, you will be asked to enter the user
name and password. You can use any login available on the server. The login dialogue
looks as follows:
AT API 2N SmartCOM
®
Login:
Admin
Password:
2n
OK
Now you are in the AT API environment in the standby mode and can enter the
supported commands. Enter the
command or close the terminal application to log ATZ
out.