2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 44)

44
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Enter the command to display the SIM card IMSI.
at+gmi
Enter the command to display the manufacturer – 2N SmartCOM
®
2N
®
Telekomunikace a.s.
at+gmm
Enter the command to display the model - . 2N SmartCOM
®
at+gmr
Enter the command to display the current firmware version - SC_vxx.xx.
at+gsn
Enter the command to display the GSM module IMEI.
ati
Enter the command to display the model - . 2N SmartCOM
®
ati3
Enter the command to display the current firmware version - SC_vxx.xx.
ati4
Enter the command to display the serial number. 2N SmartCOM
®
ato
Enter the command to switch the port from the command mode to the
transparent mode.
ata
Enter the command to switch the port from the command mode to the
transparent mode during an incoming TCP connection ringing.
ath
Enter the command to terminate (reject) an incoming TCP connection ringing.
ats0?
Enter the command to display the automatic answering of incoming calls.
0 - means that incoming calls will be ignored and should be answered
manually using the ata command.
Digit – count of rings after which the incoming call is answered
automatically.
ats0=5