2N M2M Solution 2N SmartCom - User Manual 1.9.0 - Manual (Page 52)

52
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Enter the command to define the WMbus transmission channel. Setting options:
1 - 10.
169.406250 MHz (Channel 1a)
169.418750 MHz (Channel 1b)
169.431250 MHz (Channel 2a)
169.443750 MHz (Channel 2b)
169.256250 MHz (Channel 3a)
169.458750 MHz (Channel 3b)
169.437500 MHz (Channel g)
169.412500 MHz (Channel 1)
169.437500 MHz (Channel 2)
169.462500 MHz (Channel 3)
at^scwmbus="preamble_len",0
Enter the command to define the frame format. 0 means 4 (short) / Frame
format A. 1 - 70 (long) / Frame format A.
at^scwmbus="Install_mode",0
Enter the command to switch the normal and filter off options. In the normal
mode, data are received from the defined modules only and the other modules
are ignored. In the filter off mode, the module receives and saves all data from
all modules.
Setting options: 0 - normal, 1 - filter off.
at^scwmbus="restart"
Enter the command to restart the WMbus module.
at^scwmbus="sniff"
Enter the command to enable the 'sniff' mode to make the WMbus module
capture and display all messages from the devices in the vicinity. After the
command is entered, the connect message gets displayed and the terminal starts
writing out the messages. Press Enter to quit. The disconnect message will be
displayed for confirmation.
at^scwmbus="module_type"
Enter the command to display information on the WMbus module. Response
example: ^SCWMBUS: "MODULE_TYPE","RC1180-MBUS3,2.00,3.14"
at^scwmbus?
Enter the command to display the currently set Ethernet parameters.
at^scwmbus=?
Enter the command to display the Wireless M-Bus setting options.