Rockwell Automation 20D PowerFlex 700S Drive Ph I Control, Frames 1...11 - Manual (Page 43)

Installation/Wiring 1-29
Input/Output Connection Examples — 2-Wire Control Required Parameter Changes
High Speed Inputs
12 or 24V DC Sourcing High Speed Inputs, Used for 2 Wire Control - using
the internal power supply
• Set the value of Parameter 839 [DigIn2 Sel] to a
value of 3 - Run
• Set Parameter 153 [Control Options], bit 9 “2W
Coast Stop” to make the drive coast stop when
input 2 goes low
• Reset Parameter 153 [Control Options], bit 9
“2W Coast Stop” to make the drive ramp stop
when input 2 goes low
• Reset Parameter 153 [Control Options], bit 8
“3Wire Control” for two wire control
Sourcing High Speed Inputs, Used for 2 Wire Control - using an
external power supply Note: +12V and +24V are also available from
TB1 Top 10 & 11.
Table 1.O TB2 - Row T (Top) Wiring Examples
3 5 6 2 1
Run-Stop
7
Power
Common
(Return)
12 or 24V DC
Power Supply
3 5 6
Run-Stop