Rockwell Automation 20D PowerFlex 700S Drive Ph I Control, Frames 1...11 - Manual (Page 55)

Chapter
3
Programming and Parameters
Chapter 3 provides a complete listing and description of the PowerFlex
700S parameters. The parameters can be programmed (viewed/edited) using
a HIM (Human Interface Module). As an alternative, programming can also
be performed using DriveTools™ software and a personal computer.
About Parameters To configure a Drive module to operate in a specific way, drive parameters
may have to be set. Three types of parameters exist:
• ENUM Parameters
These parameters allow a selection from 2 or more items
• Bit Parameters
These parameters have individual bits associated with features or
conditions. If the bit is 0, the feature is off or the condition is false. If
the bit is 1, the feature is on or the condition is true.
• Numeric Parameters
These parameters have a single numeric value (i.e. 0.1 Volts).
The example on the following page shows how each parameter type is
presented in this manual.
For information on... See page
About Parameters 3-1
How Parameters are Organized 3-3
Parameter Data in Linear List Format 3-16
Parameter Cross Reference By Name 3-96