Rockwell Automation 20D PowerFlex 700S Drive Ph I Control, Frames 1...11 - Manual (Page 54)

2-4 Start-Up
Table 2.A Start-Up Menu
Note: In 2-wire mode, the drive will start when the HIM “Start” is pressed
and stop when the HIM “Start” is released. The recommended mode
of use for the Start-Up Routine is 3-wire control, Parameter 153
[Control Options], Bit 8 set to “1”.
PowerFlex 700S
Start-Up
Motor Control Motor Data
Feedback
Configuration
Power Circuit Test Direction Test
Motor Tests Inertia Measure Speed Limits Speed Control Start / Stop / I/O
Select Motor Control
Mode
Select DB Resistor
Enter Motor NP Data
Power & Units
FLA
Volts
Hertz
RPM
Poles
Setup / Select
Encoder
Resolver
Hi-Res Encoder
Linear Sensor
Diagnostic Check for
Drive Power Circuit
Verify Direction
Field Oriented
Control: Measure
Stator Resistance,
Leakage Inductance,
Magnetizing
Inductance
PMag Motor: Encoder
Offset, Stator
Resistance, Stator
Inductance, Back EMF Measure System
Inertia
Select Direction
Control
Set FWD, REV and
ABS Speed Limits
Select Sources For All
Speed References
Configure:
Digital Inputs, Digital
Outputs, Analog
Inputs, Analog Outputs
Done /
Exit
Esc
Down 1 level or Select
Back 1 level or 1 selection
Scroll all choices