Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 103)

6–13
Publication 1336 FORCE–5.13 –– September, 1998
306 Channel B LED State
[ChB LED State]
ChB LED State displays the current LED state for
channel B. The LED states correspond to LEDs
D13, D14, and D15 on the PLC Communications
Adapter Board.
Parameter Number 306
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 5
File – Group Diagnostics – Info
Enums 0 = Off 1 = Red 2 = Green
3 = Yellow 4 = Flash Green 5 = Flash Red
307 PLC Communications Board Status
[PLC Comm Status]
PLC Comm Status displays the status of the PLC
Communications Adapter Board. You can use this
parameter to determine if no fault occurred, or if a
warning, soft fault, or hard fault occurred.
Parameter Number 307
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 3
File – Group Diagnostics – Info
Enums 0 = No Faults 1 = Drv Warning 2 = Drv Soft Flt 3 = Drv Hard Flt
309 Language Select
[Language Sel]
You can use Language Sel to choose the language
you want the PLC Communications Adapter Board
to use for parameter and fault display text.
Currently, only English is available.
Parameter Number 309
Parameter Type Read/Write, Non–Linkable Sink
Display Units / Drive Units None
Factory Default 0
Minimum Value 0
Maximum Value 1
File – Group Startup – Drive Data Group
Diagnostics – Info
Enums 0 = English 1 = Alternate Language (not currently available)
314 Data Input A1
[Data In A1]
Data In A1 contains the first image word from the
SCANport output image table.
Parameter Number 314
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – SCANport I/O
315 Data Input A2
[Data In A2]
Data In A2 contains the second image word from the
SCANport output image table.
Parameter Number 315
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – SCANport I/O
316 Data Input B1
[Data In B1]
Data In B1 contains the third image word from the
SCANport output image table.
Parameter Number 316
Parameter Type Read Only, Source
Display Units / Drive Units None
Factory Default 0
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – SCANport I/O