Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 19)

1–3
Publication 1336 FORCE–5.13 –– September, 1998
To select your input voltage, you need to set the discrete I/O
jumpers.
!
ATTENTION: To avoid damaging the PLC
Communications Adapter Board, you must set all
discrete I/O jumpers to the same input voltage applied
to the PLC Communications Adapter Board. The
voltage must be either 24V dc or 120V ac.
Set this discrete
I/O jumper:
To set this input: To either:
DR EN Drive Enable 24V dc or 120V ac
M THERM Motor Thermoguard 24V dc or 120V ac
N STOP Normal Stop 24V dc or 120V ac
X FLT External Fault 24V dc or 120V ac
You can use jumper J3 on the PLC Communications Adapter Board
to either allow (enable) or not allow (disable) writes to Battery
backed Random Access Memory (BRAM).
Choose: To:
EN (Enabled) Allow writes to BRAM.
DIS (Disabled) Not allow writes to BRAM.
Two terminal blocks, TB20 and TB21, are provided at the bottom of
the PLC Communications Adapter Board for discrete and analog I/O
wiring.
To make the connections more easily, you can pull apart the terminal
blocks when connecting the cables.
Both terminal blocks accept a maximum wire size of 3.3 mm 2 (12
AWG) and a minimum wire size of 0.60 mm 2 (30 AWG). Maximum
torque is 0.79 N–m (7 lb–in). Recommended control signal wire is:
Belden
number:
Description for equivalent:
8760 0.750 mm 2 (18 AWG), twisted pair, shielded
8770 0.750 mm 2 (18 AWG), 3–conductor, shielded
9460 0.750 mm 2 (18 AWG), twisted pair, shielded
Setting Your Input Voltage
120V
24V
Writing to BRAM
EN
DIS
BRAMJ3
Terminal Block Locations
"