Mounting the plc communications adapter board – Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx User Manual
Page 18
1–2
Publication 1336 FORCE–5.13 –– September, 1998
To mount your PLC Communications Adapter Board on to your
1336 FORCE, you need to:
!
ATTENTION: To avoid a shock hazard, assure that
all power to the drive has been removed before
proceeding.
1. Place the PLC Communications Adapter Board over the keyed
mounting slots.
2. Slide the board up into the main control board connector J1.
3. Secure the board to the 1336 FORCE mounting plate using the
two Phillips–head screws that are provided with the kit.
The following illustration shows the main control board of the 1336
FORCE with the PLC Communications Adapter Board mounted on
it.
1336 FORCE
Mounting Plate
Motor Control
Board
Keyed Mounting Slot
Phillips–Head Screw
Keyed Mounting Slot
Phillips–Head Screw
PLC Communications
Adapter Board
J1
Mounting the PLC
Communications Adapter
Board