Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx User Manual
Page 270
Index
I–2
Publication 1336 FORCE–5.13 –– September, 1998
choosing protocol, 2–2
command set, 4–3– 4–8
features, 4–1
message instruction, 4–2
DIP switches
ChA DIP Switch parameter, 6–12
ChB DIP Switch parameter, 6–12
DH+, 2–8, 10–12
identifying faults in set up, 6–43
RIO adapter settings, 2–3– 2–5, 10–10
RIO scanner, 10–14
setting, 2–1– 2–8
baud rate, 2–2
DH+ station address, 2–8
full rack for RIO scanner, 2–6
last/not last group, 2–3
protocol, 2–2
rack configuration for RIO scanner,
rack size for RIO adapter, 2–3
redundant RIO mode, 2–4
RIO rack address, 2–5
RIO starting group, 2–4
discrete PLC controller I/O data transfer,
E
F
Faults
Adapter Config Err, 8–8
Adpt BRAM cksm, 8–6
AP SW/LM Rev Err, 8–7
ChA Comm Loss, 8–11
ChA Dup Nodeaddr, 8–10
ChA G0 Rack Flt, 8–15
ChA G2 Rack Flt, 8–15
ChA G4 Rack Flt, 8–15
ChA G6 Rack Flt, 8–15
ChA Module Group, 8–9
ChA Rack Config, 8–9
ChA Rack Fault, 8–14
ChA Res/Pgm/Test, 8–13
channel A status, 6–43
channel B status, 6–44
ChB Comm Loss, 8–12
ChB Dup Nodeaddr, 8–10
ChB G0 Rack Flt, 8–15
ChB G2 Rack Flt, 8–15
ChB G4 Rack Flt, 8–15
ChB G6 Rack Flt, 8–15
ChB Module Group, 8–9
ChB Rack Config, 8–9
ChB Rack Fault, 8–14
ChB Res/Pgm/Test, 8–14
code descriptions, 8–6
description of queues, 8–4
display types, 8–6
Drv Types Differ, 8–7
Faults Cleared, 8–6
HW Malfunction, 8–8
I11 Drive Type, 8–7
identifying at ports, 6–46
LED locations, 8–1
Main BRAM Cksm, 8–7
No AP LM Exists, 8–8
Redund Diff Prot, 8–10
Redund Rack Size, 8–9
SP Comm Fault, 8–8
SP Pt1 Timeout, 8–8
SP Pt2 Timeout, 8–8
SP Pt3 Timeout, 8–8
SP Pt4 Timeout, 8–8
SP Pt5 Timeout, 8–8
SW Malfunction, 8–7, 8–10
types of, 8–4
function blocks
available block types, 5–12
overview, 5–11
functions
H
I
I/O
analog. See analog I/O
discrete. See discrete I/O
L