Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 17)

Chapter
1
Publication 1336 FORCE–5.13 –– September, 1998
Installing and Wiring Your PLC
Communications Adapter
Board
Chapter 1 provides information so that you can:
•
mount the PLC Communications Adapter Board
•
configure and connect the communications
•
configure and set up the discrete inputs and analog I/O
Important: The installation and wiring information in this manual
is specific to the PLC Communications Adapter Board.
For information about mounting the drive, connecting
the motor leads, or connecting the power, refer to the
1336 FORCE user manual.
The following illustration shows the PLC Communications Adapter
Board.
Keyed Mounting Slot
Language Module
Terminal Block TB20:
Discrete I/O Connections Terminal Block TB21:
Analog I/O Connections
J1 Control Board Interface
Keyed Mounting Slot
BRAM Jumper J3
Voltage Selection
Inputs
AP Status –– D1
AP Status –– D2
Fault Out –– D4
Ext Fault –– D5
Norm Stop –– D7
Motor Thermo –– D9
Drive Enable –– D11
DP Status –– D3
DP Status –– D6
Channel A Status –– D8
Channel A Status –– D10
Channel A Status –– D12
Channel B Status –– D13
Channel B Status –– D14
Channel B Status –– D15
Configuration DIP Switches
Channel A Channel B
U2 U3 U4 U5
Channel A Connector
Channel B Connector
Chapter Objectives