Rockwell Automation 1336T PLC Comm. Adapter, Series B, FRN 2.xx-3.xx - Manual (Page 114)

6–24
Publication 1336 FORCE–5.13 –– September, 1998
356 Channel A Remote I/O Output 5
[ChA RIOA Out 5] –– adapter mode
[ChA/B RIOA Out5] –– adapter mode with redundancy
[ChA RIOS Out 5] –– scanner mode
ChA RIOx Out 5 contains the sixth word or data
group to the PLC controller input image table. The
data is transferred to the PLC controller every rack
scan. The PLC Communications Adapter Board can
provide this value directly. Other drive functions can
provide this value through a configuration link.
Parameter Number 356➀
Parameter Type Read/Write, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
➀ This parameter is not available if you set up channel A for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.
357 Channel A Remote I/O Output 6
[ChA RIOA Out 6] –– adapter mode
[ChA/B RIOA Out6] –– adapter mode with redundancy
[ChA RIOS Out 6] –– scanner mode
ChA RIOx Out 6 contains the seventh word or data
group to the PLC controller input image table. The
data is transferred to the PLC controller every rack
scan. The PLC Communications Adapter Board can
provide this value directly. Other drive functions can
provide this value through a configuration link.
Parameter Number 357➀
Parameter Type Read/Write, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
➀ This parameter is not available if you set up channel A for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.
358 Channel A Remote I/O Output 7
[ChA RIOA Out 7] –– adapter mode
[ChA/B RIOA Out7] –– adapter mode with redundancy
[ChA RIOS Out 7] –– scanner mode
ChA RIOx Out 7 contains the eighth word or data
group to the PLC controller input image table. The
data is transferred to the PLC controller every rack
scan. The PLC Communications Adapter Board can
provide this value directly. Other drive functions can
provide this value through a configuration link.
Parameter Number 358➀
Parameter Type Read/Write, Sink
Display Units / Drive Units None
Factory Default None
Minimum Value –32767
Maximum Value +32767
File – Group Communications I/O – Channel A
➀ This parameter is not available if you set up channel A for DH+. Availability also
depends on the selected rack size.
Note: All eight words are displayed regardless of the rack size. Only the number of words corresponding to the rack size and protocol
(with or without block transfer) are functional.