Rockwell Automation 2755 AdaptaScan Software - Manual (Page 121)

8–12
Publication 2755-838
Destination
Specify the destination node and address to receive the bar code data
when the Reader is selected as a Master.
Select: To:
Node Specify the node address of the device that is to receive the
bar code data. Select a value 0 to 31.
N9:Offset Specify the processor interface file offset address to receive the
bar code message. Select an address in the range of 0 to
32,765. The default is 100.
The Used By dialog lists other Readers that use the same serial port
configuration. Use this dialog when you make changes to a
configuration and you want to make changes to other Readers using
the same configuration.
Currently Used By
Displays the Reader configurations that use the same serial port
setup. Highlight the configuration you want to access and click the
Goto button.
Viewing Readers
with the Same Serial Port
Configuration
☞ Or double-click a
configuration and click the
Goto button.