Rockwell Automation 2755 AdaptaScan Software - Manual (Page 83)

Chapter
6
Defining Labels
This chapter describes the dialog boxes that define a label setup. A
label setup defines the label contents the Reader is expected to read.
Section Page
Helpful Hints 6–1
What is a Label? 6–2
What is a Label Setup? 6–3
Managing Bar Code Labels 6–4
Defining a Bar Code Label 6–5
Used By Dialog 6–7
Defining Symbols for a Bar Code Label 6–8
Selecting Symbologies for a Bar Code Label 6–10
When defining a label setup:
•
Enable only the symbologies the Reader is expected to scan to
increase the Reader’s response rate.
•
Define as many parameters as you can for each label and
symbology to prevent the possibility of a misread.
•
You can define label setups at any time (before or after other
Reader settings). However, label setups are assigned to a Reader
using the Decoder dialogs. It may be easier to create the label
setups prior to defining the operation of the decoder.
•
For initial setup use the default settings when possible. When a
configuration is working, change decoder settings one at a time
while verifying the operation of the Reader (see Chapter 13).
Chapter Objectives
Helpful Hints