Rockwell Automation 2755 AdaptaScan Software - Manual (Page 63)

4–16 Getting Started
Publication 2755-838
This section shows how to specify when and what labels are to be
decoded by the Reader.
To configure the decoding parameters:
1. From the Project 1 window, click the Decoder button.
The Decoder dialog opens.
The label name Label 1 should appear in the Bar Code Label list.
If the name doesn’t appear, you need to redefine the label setup.
Since the project contains a single Reader configuration, Bar
Code Reader 1 should appear as the trigger source for decoding.
1. Select Label 1
2. Select
Bar Code Reader 1
3. Select Timer
2. Select Timer from the Input list. Timer allows the Reader to
trigger decoding without an external input (package detect). This
is useful for simulating a package detector during setup.
3. Click Save and then Close to save the decoding parameters.
You return to the Project window.
Configuring the Decoder