Rockwell Automation 2755 AdaptaScan Software - Manual (Page 69)

4–22 Getting Started
Publication 2755-838
This section describes how to configure the Reader RS-232 port
(inside wiring base).
To configure the serial port:
1. From the Project 1 window, click the Serial Port button.
The Serial Port dialog opens. Verify the following settings:
1. Select Terminal
2. Select
9600 Baud
4. Select
No Parity,
8 Data and
1 Stop Bit.
3. Select 0 message
length (sends all
data regardless of
length).
5. Select
RS-232 Connection
2. Click Save and then Close to save the serial port configuration.
You return to the Project 1 window.
Note: If using the DL10 Dataliner, make sure that the DL10
configuration is set to match the Reader serial port configuration:
Terminal Protocol
9600 Baud
No Parity
8 Data Bits
1 Stop Bit
Setting the
Serial Port