Rockwell Automation 2755 AdaptaScan Software - Manual (Page 72)

4–25 Getting Started
Publication 2755-838
This section shows how to download the Bar Code Reader 1
configuration to the Reader.
Verify the computer to Reader connections described on page 4–5.
To download the Bar Code Reader 1 configuration:
1. Select Go On–Line from the Communications menu.
The Reader will be detected and displayed in the Project window:
2. From the Project 1 window, verify that Bar Code Reader 1 is
selected.
3. Set the Reader address by clicking the Device button.
The Device dialog opens allowing you to change the address.
The Reader is shipped with a default address of 63.
4. If you want to change the address, click Apply to send the
address to the Reader.
It will take a few seconds for the address download to occur.
5. Click Save and then Close.
You return to the Project 1 window.
6. With the Reader configuration highlighted, click the Download
button to download the configuration to the Reader.
The following messages appear during the download.
Resetting. Please Wait . . .
Sending. Please Wait . . .
When the download is complete, the messages disappear.
7. Click the Scanner button and select Triggered for the laser light
control. Click Apply to send the changed setting to the Reader.
8. The Reader should now be turning the scan beam on and off at 1
second intervals.
Downloading
the Configuration