Rockwell Automation 2755 AdaptaScan Software - Manual (Page 142)

10–5
Publication 2755-838
Triggered By
Specifies the trigger that sends a message to the host. The Reader
sends messages at the end of a trigger or when data is available.
Note: If DeviceNet is selected as the host (page 10–10), messages
are queued until requested by the DeviceNet master (see Message
Flow Control page 10–13). The trigger controls when messages are
placed in the queue.
Select To
Enable Enable the message trigger. If not selected, mes-
sages are not sent.
Device Select the Reader that is the source of the
trigger.
Input Select the input on the specified device (Reader) to
trigger a message send.
Send at End of Trigger Send a message at the end of a trigger.
Send When All Fields Are Sa-
tisfied. Send a message immediately when all of the ex-
pected fields have been decoded or at the end of
the trigger.
Any configured input is available as a message trigger, including:
Select To
Package Detect Use the package detect input as the trigger source.
Timer Use the internal Reader timer as the trigger source.
ASCII
Command Use an ASCII command as the trigger source.
Input Timer Use the input timer as the message trigger.
DeviceNet
Inputs 1
!7
Use a DeviceNet input as the message trigger.
[Decoder] Use the decode trigger as the trigger source.
[Package] Use the package trigger as the trigger source.
[Match Table] Use the match table trigger as the trigger source.
[Message] Use the same message trigger used by another Reader.