Rockwell Automation 2755 AdaptaScan Software - Manual (Page 157)

11–5
Publication 2755-838
Auto-Load allows you to enter a Match Entry data string by scanning
the desired bar code label. Usually, the Auto-Load input is provided
by a switch or push button connected to one of the AdaptaScan I/O
in the wiring base.
To configure a Match Entry for Auto-Load:
1. On the Match Function dialog (page 11–9), select Auto-Load as
the function.
2. Use the Auto-Load Trigger Source dialog (page 11–19) to define
the trigger source.
After the AdaptaScan has been configured and running, Auto-Load
symbol data by triggering the decoder while the desired symbol is
being scanned and decoded. The Auto-Load input must be energized
before the decoder is triggered and must remain on until the decoder
trigger goes off.
Decoder Trigger
Trigger
Data
Scanned
Auto-Load Triggered Prior
to Decoder Trigger
Auto-Load Trigger
Keep Auto-Load Trigger
On Until Decoder Trigger is Off.
The following page shows a typical Auto-Load sequence.
Notes:
A string that is auto-loaded does not appear in the Rule field of the
Match Function dialog.
Auto-Load clears the Match Counters.
Using Auto-Load