Rockwell Automation 2755 AdaptaScan Software - Manual (Page 122)

Chapter
9
Configuring Discrete Inputs
and Outputs
This chapter defines the operation of the Reader’s discrete I/O.
Section Page
Helpful Hints 9–1
Types of Outputs 9–2
Types of Inputs 9–3
Configuring Inputs and Outputs 9–5
Configuring Discrete Inputs & the Package Detect 9–6
Configuring Discrete Outputs 9–8
Configuring the Timer 9–9
Configuring Input Timers 1 and 2 9–10
Configuring an ASCII Trigger 9–12
DeviceNet I/O 9–13
Configuring DeviceNet Inputs 9–15
Configuring DeviceNet Outputs 9–16
When setting up discrete inputs or outputs:
•
If possible, use the package detect input not a discrete input for a
package detector. The package detect input is used with a current
sinking or hard contact detector (usually a photo-electric device).
•
Input and output devices have default names which can be
changed. If you change the I/O name, make sure the new name
describes both the type of input and the output number (1 or 2) or
the input number (1 or 2).
Chapter Objectives
Helpful Hints