Rockwell Automation 2098-IPD-xxx Ultra5000 Intelligent Positioning Drives Installation Manual - Manual (Page 145)

Publication 2098-IN001E-EN-P — April 2002
Catalog Numbers and Accessories C-9
Mating Connector Kits
The Ultra5000 has two serial connectors, one motor feedback
connector, two I/O connectors, and one terminal block for power
connections. Use the following table to identify the mating connector
kits for your Ultra5000. Refer to the chapter
Ultra5000 Connector
Information beginning on page 2-1 for pin, signal, and wiring
information.
The following table lists mating connectors that are not available from
Rockwell Automation. Please contact Amp at 1-800-522-6752 or a
distributor for additional information.
1 Accepts 22-28 AWG wire.
2
Accepts 20-24 AWG wire.
3 Ferrules are only required for use with shielded backshell kits.
Description Catalog Number
Mating Connector Kit (9-pin D-shell) 2090-UXCK-D09
Mating Connector Kit (15-pin high density D-shell) 2090-UXCK-D15
Mating Connector Kit (Terminal Block) 2090-UXCK-TB
Connector Components CN2
Motor Feedback
15-Pin
High-Density D-Shell
CN3
Serial
9-Pin
Standard-Density D-Shell
Mating Connector 748364-1 205204-4
Crimp Pin Contacts
748333-4
1
5-66506-7
2
Unshielded Backshell Kit 748678-1 748678-1
Shielded Backshell Kit 745171-5 745171-5
Ferrules
3 745508-6 745508-6