Assigning your ultra5000 devicenet address, Assigning your ultra5000 devicenet address -12 – Rockwell Automation 2098-IPD-xxx Ultra5000 Intelligent Positioning Drives Installation Manual User Manual
Page 72
Publication 2098-IN001E-EN-P — April 2002
3-12
Connecting Your Ultra5000
4. Insert each wire into the appropriate clamping cavity of the
plugable screw connector, according to the color of the cable
insulation.
Tighten the clamping screws to secure each wire.
5. Use an 1/8 inch flat blade screwdriver to firmly attach wires in the
connector.
Figure 3.13
Wiring the DeviceNet connector
6. Attach the Ultra5000 with DeviceNet to the DeviceNet network.
Assigning Your Ultra5000 DeviceNet Address
Use the following procedures to configure your Ultra5000 drive
(2098-IPD-xxx-DN, and -HVxxx-DN) using Ultraware software and
apply power to the drive.
To configure your Ultra5000 drive with DeviceNet:
1. Verify that there is no power applied to the drive, and the
DeviceNet cable is connected (refer to figures
for the
connector location).
Terminal
Cable Color
Designation
5
Red
V +
4
White
Can_H
3
Bare
Shield
2
Blue
Can_L
1
Black
V -
1
2
3
4 5
2
3
1
4
5
Red (V+)
White (Can_H)
Bare (Shield)
Blue (Can_L)
Black (V-)
Plug Connector