Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 160)

FactoryTalk EnergyMetrix Software
160
 Fields
 Date/Time of waveform
This displays date and time when the waveform was captured.
 Total cycles
This displays the number of cycles captured.
 Shoe Channel
This shows which channels are displayed and allows for selection of channels to
display.
 Show Markers
This shows for each channel if markers are shown and allows for selection of
channels to display markers for.
 Buttons
 Trigger a Capture
This triggers a new waveform capture in the Powermonitor 3000. There must be
at least one open capture slot in order to trigger a new capture.
 Delete Selected Waveform
This button presents a drop-down menu allowing clearing of one or all waveform
captures.
 Delete All Waveforms
This button presents a drop-down menu allowing clearing or one or all waveform
captures.
Voltage/Current Tab
This displays real-time data from an Allen-Bradley Powermonitor 5000 unit.
 Voltage Data
This displays voltage information produced by the power monitor, including the
following:
 Line to line voltage per phase and average
 Line to neutral voltage per phase and average (in Wye, single-phase, and high-leg
Delta metering modes)
 Current Data
This displays current information produced by the power monitor, including the
following:
 Current per phase and average
 Neutral current
 Frequency
 Last cycle frequency
 Average frequency over the last N cycles (determined by power monitor
configuration)
 Phase Rotation