Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 44)

FactoryTalk EnergyMetrix Software
44
Installation (32-bit)
Pre-installation Checks
1. Check out the server for required customer-provided software:
 Windows 2003 R2 Server, set up in the Application Server role. ASPNET must be
installed. Active Server Pages must be enabled in Internet Information Services.
Network COM+ Access must be enabled. The server can not be set up as a
Domain Server. FactoryTalk EnergyMetrix software installation on
Windows 2000 Server is no longer supported.
 SQL 2005 or 2008 Server, installed and set up for mixed mode authentication
(SQL Server and Windows). TCP/IP access must be enabled.
 If the SQL database server is hosted on a remote server, you must download from
Microsoft (if necessary) and install Microsoft SQL Server 2005 or 2008 Express
Edition on the FactoryTalk EnergyMetrix server. This installs the osql.exe
application FactoryTalk EnergyMetrix software uses to connect to the remote
database.
 IIS 6, 7, or 7.5 installed and enabled to run.
2. You must use a machine administrator login in Windows and have full administrator
rights for SQL.
3. Ping all Ethernet devices (meters and/or controllers) the customer wishes to connect
to.
 Correct communication to any meters that don't respond.
 Verify communication with Allen-Bradley Ethernet power monitors via their
built-in web page.
Installation
1. Verify the Application Server role configuration in the host Windows Server
operating system.
These are the minimum required components:
 ASPNET
 COM+ Services
 Internet Information Services (IIS), all options
Make any necessary changes before proceeding with the installation.
See Installation (64-bit) on page 37 for instructions to install FactoryTalk
EnergyMetrix software on a 64-bit operating system.