Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 30)

FactoryTalk EnergyMetrix Software
30
Power Quality Reports
Runs a report that combines a graph and a grid display of power quality (sag and swell)
events. The power quality report can only be used with Allen-Bradley PowerMonitor 3000
M6 and M8 models with their sag and swell setpoints configured. The Enable PQ events
logging flag must be selected in the Device setup page. With this flag set, FactoryTalk
EnergyMetrix periodically reads the power monitor event log and stores sag and swell
events in the database. Each sag and swell record lists the time, duration and maximum
deviation of the sag or swell. The power quality report displays the events logged during
the selected report interval on a ITI/CBEMA chart and in a grid (tabular) listing.
Pareto Chart Report
Runs a report on consumption values of a selection of meters or groups. The Pareto chart
displays each meter or group's consumption as a bar chart, with the bars arranged in order
of decreasing consumption. A line chart indicating the cumulative consumption of the
groups or meters, starting at zero and ending with 100%, is overlaid against the bar chart.
The Pareto chart report help identify the areas in your facility that use the most energy.
ReportsPlus Reports
ReportsPlus reports are available as part of the ReportsPlus option.
Automatically Run Reports
The reports listed above can be set up to run automatically, either on a schedule or in
response to an alarm.
System Configuration Report
This report can be configured to document the configuration of the FactoryTalk
EnergyMetrix project.
ReportsPlus Reports
ReportsPlus provides you a package of additional reports that are set up and viewed in the
same way as standard reports. Like standard reports, ReportsPlus reports can be
configured to automatically run on a schedule and optionally send the report output to one
or more email addresses. ReportsPlus reports can be identified by a distinctive icon in the
report list.
Multi-purpose Report
The Multi-purpose Report (MPR) supports a free-form type of report output that is driven
by script code stored in a Multi-purpose Report Script.
Efficiency Report
The purpose of this report is to give you information on the ‘energy efficiency’ of part or
all of your process, plant or enterprise. You will be able to define an efficiency equation
and then execute the equation over a period of time and a group of meters.