Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 83)

4 • Set up Your System Architecture
83
Set up an Allen-Bradley Power Monitor Tag
FactoryTalk EnergyMetrix software makes setup of Allen-Bradley power monitor tags
easy and straightforward. Follow these steps to set up an Allen-Bradley power monitor
tag.
1. In the Add a Meter Tag window, leave the Meter tag type as Device.
2. Select a tag from the Select device tag to load data pull-down menu.
3. Note that the remaining fields are automatically filled in.
4. Set the Log rate to the polling interval you desire.
5. Click Save to save the new tag, or Cancel to exit without saving.
Set up an Allen-Bradley Motor Protection Device Tag
Follow these steps to set up an Allen-Bradley motor protection device tag.
1. In the Add a Meter Tag window, leave the Meter tag type as Device.
2. Select a tag from the Select device tag to load data pull-down menu.
3. Note that the remaining fields are automatically filled in.
Do not change any of the remaining fields from the values that FactoryTalk
EnergyMetrix software fills in automatically. Changing the address, data format,
scaling, value type, and other parameters may prevent logging of the tag or may
cause the tag to be logged with erroneous data.