Rockwell Automation 9307 FactoryTalk EnergyMetrix - Manual (Page 61)

4 • Set up Your System Architecture
61
SLC 500 Controller on (communication type)
Connects to an Allen-Bradley SLC 500 programmable controller. The following
communication networks are supported:
 Ethernet network - CSP/PCCC addressing
 Serial network - DF1 full-duplex
 DH+ network - Data Highway Plus
ControlLogix Controller on (communication type)
Connects to an Allen-Bradley ControlLogix (or Logix family) controller, such as
CompactLogix controller. With this device class, FactoryTalk EnergyMetrix software can
log only PLC/SLC mapped tags. You can log Logix family native tags by using RSLinx
Classic OPC.
 ControlNet network
 Ethernet network - EtherNet/IP
 Serial network - DF1 full duplex
 DH+ network - Data Highway Plus
PLC-5 Controller on (communication type)
Connects to an Allen-Bradley PLC-5 programmable controller. The following
communication networks are supported:
 ControlNet network
 Ethernet network - CSP/PCCC addressing
 Serial network - DF1 full duplex
 DH+ network - Data Highway Plus
MicroLogix Controller on an Ethernet Network
Connects to an Allen-Bradley MicroLogix controller 1000, 1100, 1200, 1400, 1500.
PowerMonitor II (model) Unit on (communication type)
Connects to an Allen-Bradley 1403 PowerMonitor II. Model LM specifies the limited
metering model. The following communication are supported:
 DeviceNet network (RT option is not supported for DeviceNet)
 Ethernet network - CSP/PCCC addressing
 Remote I/O network - Must have a parent device such as a PLC-5, SLC 500, or
ControlLogix controller.
 Serial network - Allen-Bradley DF1 half duplex master/slave
Serial communication will not provide adequate performance in most cases. Please
contact Rockwell Automation technical support for more information.