Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 12)

1-2 DeviceNet Adapter for use with DPI AC Drives
• Master-slave or peer-to-peer hierarchies that can be set up so
that the adapter and connected SP600 drive transmit data to and
from either a scanner or another SP600 drive on the network.
• User-defined fault actions that determine how the adapter and
SP600 drive respond to communication disruptions on the
network and controllers in idle mode.
• Faulted node recovery is supported. You can configure a device
even when it is faulted on the network if you have a configuration
tool that uses faulted node recovery and have set the data rate
switch to “PGM” (Program). With the PGM setting, the adapter
uses parameter settings for the data rate and node address
instead of switch settings.
1.2 Related Documentation
Refer to the following related publications as necessary for more
information. All of the publications are available from
http://www.theautomationbookstore.com.
• D2-3485 SP600 AC Drive User Manual
• D2-3488 VS Utilities Getting Results Manual
Online help installed with the software
• DN-2.5 DeviceNet Product Overview
• DN-6.7.2 DeviceNet Cable System Planning and
Installation Manual
• DN-6.5.16 DeviceNet Starter Kit
• 1756-5.66 ControlLogix DeviceNet Scanner
Installation Instructions
• 9399-WAB32GR Getting Results with RSLinx
Online help installed with the software
• 9399-RL53GR RSLogix 5 Getting Results Guide
Online help installed with the software
• 9399-RL50GR RSLogix 500 Getting Results Guide
Online help installed with the software
• 9399-RLD300GR RSLogix 5000 Getting Results Guide
Online help installed with the software
• 9399-DNETGR RSNetWorx for DeviceNet Getting Results
Guide
Online help installed with the software
• 1747-5.8 DeviceNet Scanner Module Installation
Instructions