Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 7)

Contents V
List of Figures
Figure 2.1 – Components of the DeviceNet Adapter .................................. 2-1
Figure 3.1 – Setting the Node Address....................................................... 3-2
Figure 3.2 – Setting the Data Rate ............................................................. 3-2
Figure 3.3 – Connecting a 5-Pin Linear Plug to the Cable.......................... 3-3
Figure 3.4 – DPI Ports and Internal Interface Cables ................................. 3-4
Figure 3.5 – Mounting and Grounding the DeviceNet Adapter ................... 3-5
Figure 4.1 – Accessing the DeviceNet Parameters using the LCD OIM..... 4-2
Figure 4.2 – Configure Drivers Dialog Box with a Configured Driver.......... 4-3
Figure 4.3 – Sample DeviceNet Network (Graph View).............................. 4-4
Figure 4.4 – EDS Wizard Screen................................................................ 4-6
Figure 4.5 – Sample SP600 Drive Dialog Box (Drive Parameters Tab) ..... 4-7
Figure 4.6 – DeviceNet Node Address Screen on an LCD OIM ................. 4-7
Figure 4.7 – DeviceNet Data Rate Screen on an LCD OIM........................ 4-8
Figure 4.8 – I/O Configuration Screen on an LCD OIM .............................. 4-8
Figure 4.9 – Master-Slave Input Screen on an LCD OIM ........................... 4-9
Figure 4.10 – Master-Slave Output Screen on an LCD OIM .................... 4-10
Figure 4.11 – Peer Out Enable Screen on an LCD OIM........................... 4-10
Figure 4.12 – Peer A Output Screen on an LCD OIM............................... 4-11
Figure 4.13 – Peer B Output Screen on an LCD OIM............................... 4-11
Figure 4.14 – Min Peer TX Time and Peer Out Skip Screens on an
LCD OIM ............................................................................ 4-11
Figure 4.15 – Peer Input Enable Screen on an LCD OIM......................... 4-12
Figure 4.16 – Peer Node to Input Screen on an LCD OIM ....................... 4-12
Figure 4.17 – Peer A Input Screen on an LCD OIM ................................. 4-12
Figure 4.18 – Peer B Input Screen on an LCD OIM ................................. 4-13
Figure 4.19 – Peer Logic Command Mask Screen on an LCD OIM ......... 4-13
Figure 4.20 – Peer Reference Adjust Screen on an LCD OIM ................. 4-14
Figure 4.21 – Minimum Peer Receiving Time Screen on an LCD OIM .... 4-14
Figure 4.22 – Peer Fault Action Screen on an LCD OIM.......................... 4-15
Figure 4.23 – I/O Configuration Screens on an LCD OIM ........................ 4-16
Figure 4.24 – COS Status Mask Configuration Screen on an LCD OIM .. 4-16
Figure 4.25 – COS Fdbk Change Configuration Screen on an LCD OIM. 4-16
Figure 4.26 – Fault Action Screens on an LCD OIM................................. 4-18
Figure 4.27 – Reset Screen on an LCD OIM ............................................ 4-19
Figure 5.1 – Sample DeviceNet Network.................................................... 5-1
Figure 5.2 – Configuration View (Graph Tab) ............................................. 5-2
Figure 5.3 – Scanlist Page in the Scanner Module Dialog Box .................. 5-3
Figure 5.4 – Edit I/O Parameters Dialog Box.............................................. 5-3
Figure 5.5 – Input Page on the Scanner Module Dialog Box...................... 5-6
Figure 5.6 – Output Page on the Scanner Module Dialog Box ................... 5-7