Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 19)

Installing the DeviceNet Adapter 3-1
C
HAPTER
3
Installing the
DeviceNet Adapter
Chapter 3 provides instructions for installing the DeviceNet adapter
in an SP600 drive.
3.1 Preparing for an Installation
Before installing the DeviceNet adapter:
• Read the DeviceNet Product Overview Manual , Publication
DN-2.5, and the DeviceNet Cable System Planning and
Installation Manual , Publication DN-6.7.2. These manuals will
provide information on selecting cables, setting up a network, and
network basics.
• Verify that you have all required equipment. Refer to chapter 2,
Getting Started.
3.2 Commissioning the DeviceNet
Adapter
To commission the adapter, you must set a unique node address
and the data rate that is used by the network. (Refer to the Glossary
for details about data rates and node addresses.)
Important: New settings are recognized only when power is applied
to the adapter. If you change a setting, cycle power.
Step 1. Set the node address switches as shown in figure 3.1.
!
ATTENTION: The DeviceNet adapter contains
ESD- (Electrostatic Discharge) sensitive parts that
can be damaged if you do not follow ESD control
procedures. Static control precautions are required
when handling the adapter. Failure to observe these
precautions could result in damage to equipment.