Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 23)

Installing the DeviceNet Adapter 3-5
Step 4. Mount the adapter on the drive, using the four captive
screws to secure it in place and ground it to the drive.
Important: On an SP600 drive, tighten the screw in the lower right
hole to ground the adapter.
3.5 Applying Power
Step 1. Close the door or reinstall the cover on the drive. The
status indicators can be viewed on the front of the drive
after power has been applied.
Step 2. Ensure that the adapter will have a unique address on the
network and is set at the correct data rate or to autobaud. If
a new data rate or address is needed, reset its switches
(refer to section 3.2).
Step 3. Apply power to the network.
Step 4. Apply power to the drive. The adapter receives its power
from the connected drive and network. When you apply
power to the product and network for the first time, the
status indicators should be green after an initialization. If
the status indicators are red, there is a problem. Refer to
chapter 8, Troubleshooting the DeviceNet Adapter and
Network.
Figure 3.5 – Mounting and Grounding the DeviceNet Adapter
SP600 AC Drive
!
ATTENTION: Unpredictable operation may occur if
you fail to verify that parameter settings and switch
settings are compatible with your application. Verify
that settings are compatible with your application
before applying power to the drive. Failure to
observe these precautions could result in severe
bodily injury or loss of life.