Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 47)

Configuring the Scanner 5-1
C
HAPTER
5
Configuring the Scanner
A scanner is a separate module of a multi-module controller or a
built-in component of a single-module controller that provides
communication with an adapter connected to a network.
Chapter 5 provides instructions on how to configure a scanner to
communicate with the DeviceNet adapter and the connected SP600
drive.
5.1 Configuring a Simple Network:
An Example
After the adapter is configured, the connected drive and adapter will
be a single node on the network. This chapter provides the steps
that are needed to configure a simple network like the network in
figure 5.1. In our example, we will configure the drive for using Logic
Command/Status and Reference Feedback over the network.
Figure 5.1 – Sample DeviceNet Network
Node 0
SCL 500 Controller with
1747-SDN- Scanner
Node 62
Computer with 1770-KFD and
RSNetWorx for DeviceNet
Node 1
SP600 Drive with
DeviceNet Adapter