Rockwell Automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Drives - Manual (Page 3)

Contents I
C
ONTENTS
Chapter 1 Introduction
1.1 DeviceNet Adapter Features ......................................... 1-1
1.2 Related Documentation ................................................. 1-2
1.3 Conventions Used in This Manual ................................. 1-3
1.4 Getting Assistance from Reliance Electric..................... 1-3
Chapter 2 Getting Started
2.1 DeviceNet Adapter Components ................................... 2-1
2.2 Required Equipment ...................................................... 2-2
2.3 Installation Checklist ...................................................... 2-3
Chapter 3 Installing the DeviceNet Adapter
3.1 Preparing for an Installation........................................... 3-1
3.2 Commissioning the DeviceNet Adapter ......................... 3-1
3.3 Connecting the Adapter to the Network......................... 3-3
3.4 Connecting the Adapter to the Drive.............................. 3-4
3.5 Applying Power.............................................................. 3-5
Chapter 4 Configuring the DeviceNet Adapter
4.1 Configuration Tools........................................................ 4-1
4.2 Using the LCD OIM to Configure the Adapter ............... 4-2
4.3 Using RSNetWorx for DeviceNet ................................... 4-2
4.3.1 Setting Up RSLinx for RSNetWorx for DeviceNet 4-2
4.3.2 Going Online with RSNetWorx for DeviceNet ..... 4-4
4.3.3 Creating an Electronic Data Sheet (EDS) File..... 4-5
4.3.4 Accessing and Editing Parameters...................... 4-6
4.4 Setting the Node Address.............................................. 4-7
4.5 Setting the Data Rate .................................................... 4-8
4.6 Setting the I/O Configuration ......................................... 4-8
4.7 Selecting Master-Slave or Peer-to-Peer ........................ 4-9
4.7.1 Setting a Master-Slave Hierarchy........................ 4-9
4.7.2 Setting an Adapter To Transmit Peer-to-Peer
Data................................................................... 4-10
4.7.3 Setting an Adapter To Receive Peer-to-Peer
Data................................................................... 4-12
4.8 Selecting COS, Cyclic, or Polled I/O............................ 4-15
4.8.1 Using COS (Change of State)Data Exchange... 4-15
4.9 Setting a Fault Action................................................... 4-17
4.9.1 Changing the Fault Action ................................. 4-17
4.9.2 Setting the Fault Configuration Parameters ...... 4-18
4.10 Resetting the Adapter .................................................. 4-19
4.11 Viewing the Adapter Configuration .............................. 4-20