Dell POWEREDGE M1000E - Manual (Page 214)

186 Fabric OS Command Reference
53-1002746-01
cryptoCfg
2
--set -keyvault
Sets the key vault type. This command is valid only on the group leader.
value
Specifies the key vault type. The default is set to no value. This operand is
required. Valid values for -keyvault include the following parameters:
LKM
Specifies the NetApp LKM appliance (trusted key vault).
DPM
Specifies the Data protection Manager key repository.
SKM
Specifies one of the following: the HP Secure Key Manager (SKM) or the HP
Enterprise Secure Key Manager (ESKM). Both are opaque key repositories.
TEKA
Specifies the Thales e-Security keyAuthority (TEKA) key repository.
TKLM
Specifies the Tivoli Key Lifetime Manager (TKLM) key repository
KMIP
Specifies the Key Management Interoperability Protocol (KMIP) key
repository.
--set -failbackmode
Sets the failback mode parameter. This parameter is set on the group leader. Valid
values for failback mode include the following parameters:
auto
Enables automatic failback. In this mode, failback occurs automatically within an
HA cluster when an encryption switch or blade that failed earlier has been
restored or replaced. Automatic failback mode is enabled by default.
manual
Enables manual failback. In this mode, failback must be initiated manually after an
encryption switch or blade that failed earlier has been restored or replaced.
--set -hbmisses
Sets the number of heartbeat misses allowed in a node that is part of an
encryption group before the node is declared unreachable. This value is set in
conjunction with the time-out value. It must be configured at the group leader node
and is distributed to all member nodes in the encryption group. The following
operand is required:
value
Specifies the number of heartbeat misses. The default value is 3. The range is 1
to 15 in integer increments only.
--set -hbtimeout
Sets the time-out value for the heartbeat. This parameter must be configured at
the group leader node and is distributed to all member nodes in the encryption
group. The following operand is required:
value
Specifies the heartbeat time-out in seconds. The default value is 2 seconds. Valid
values are integers in the range between 1 and 30 seconds.