Dell POWEREDGE M1000E - Manual (Page 689)

Fabric OS Command Reference 661
53-1002746-01
portCfgDefault
2
portCfgDefault
Resets the port configuration to factory default value.
SYNOPSIS portcfgdefault [slot/][ge]port
DESCRIPTION Use this command to reset all configuration values on a specified port to their factory defaults. This
command persistently disables ports capable of routing, which is the factory default value. Use the
portCfgShow command to display the port configuration.
This command does not change the state of a port. To change the state of an E_Port, use either
switchDisable/switchEnable or portDisable/portEnable.
When issued on a Brocade 8000 in Access Gateway mode, this command resets the buffer limited mode
on all N_Ports. It also returns the maximum NPIV per port login limit to the default value of 126 on all
ports, including FCoE ports.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
slot
For bladed systems only, specifies the slot number of the port to be reset, followed
by a slash (/).
port
Specifies the number of the port to be reset, relative to its slot for bladed systems.
Use switchShow to list of valid ports.
EXAMPLES To reset a port to factory defaults:
switch:admin> portcfgdefault 1/3
To reset a GbE port to factory defaults:
switch:admin> portcfgdefault 8/ge1
To reset a an FCoE port on a Brocade 8000 in Access Gateway mode:
switch:admin> portcfgdefault 13
switch:admin> portcfgshow
Area Number: 13
Speed Level: AUTO(HW)
Fill Word: 0(Idle-Idle)
Trunk Port ON
Locked N_Port OFF
Persistent Disable OFF
LOS TOV enable OFF
NPIV capability ON