Dell POWEREDGE M1000E - Manual (Page 891)

Fabric OS Command Reference 863
53-1002746-01
portThConfig
2
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This command requires a Fabric Watch license.
For more information on port threshold configuration procedures, including default values for specific
area high/low thresholds, refer to the Fabric Watch Administrator's Guide.
OPERANDS This command has the following operands:
port_type
Specifies the port type for which to configure or display Fabric Watch settings.
This operand is optional with the --show option. With all configuration options it is
required. Valid port types include one of the following:
e-port
Configures or displays all E_Ports (not supported in Access Gateway mode).
fop-port
Configures or displays all optical F_Ports.
fcu-port
Configures or displays all copper F_Ports. This operand is supported only on
embedded platforms and only on copper ports.
port
Configures or displays all physical ports.
ve-port
Configures or displays all VE_Ports. Only a subset of areas can be configured for
this port type. When setting VE_Port thresholds for the packet loss area
(PKTLOSS), the threshold value accepts up to two decimal points, for example,
-value 0.60. The VE_Port type is not supported in Access Gateway mode.
-area area
Specifies the area monitored by the Fabric Watch daemon. This operand is
optional with the --show option. With all configuration options it is required.
The following areas are valid when configuring or displaying configuration settings
on E_Ports, optical F_Ports, copper F_Ports, and physical ports. Area values are
not case-sensitive.
CRC
Cyclic redundancy check error
ITW
Invalid transmission word
C3TX_TO
Class 3 transmit frames discarded due to timeout.
LOS
Loss of synchronization
LF
Link failure
RX
Receive error
TX
Transmit error
PE
Protocol error