Dell POWEREDGE M1000E - Manual (Page 322)

294 Fabric OS Command Reference
53-1002746-01
fcipPathTest
2
fcipPathTest
Tests the data path of the FCIP complex.
SYNOPSIS fcippathtest
[--slot slot]
[-lb_mode mode]
[-nframes count]
DESCRIPTION Use this command to verify the data paths in the FCIP complex. All data path modes run tests by
comparing Fibre Channel frames or data packets transmitted from and received by the network
processor due to the designated loopback.
This command is supported only on the Brocade 7800/FX8-24 platforms.
Executing this command causes the switch or blade to reboot.
NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
--slot slot
Specifies the slot number on which the diagnostic operates. The default is 0 and
operates on fixed-port-count products.
-lb_mode mode
Specifies the loopback mode for the test. By default, this test uses the External
(SERDES) loopback (2). Valid values are as follows:
1
Port loopback (loopback plugs)
2
External (SERDES) loopback
7
Backend bypass and port loopback
-nframes count
Specifies the number of frames to send. The test progresses until the specified
number of frames is transmitted on each port. The default value is 100.
DIAGNOSTICS When it detects failures, the test may report one or more of the following error messages:
PATH_TEST_ERR
PATH_TEST_CHIP_INIT_ERR
PATH_TEST_IMAGE_ERR
PATH_TEST_TIMEOUT_ERR
PATH_TEST_HEARTBEAT_ERR
PATH_TEST_INVALID_RESULT
PATH_TEST_GE_PORT_ENABLE_ERR
PATH_TEST_GE_PORT_DISABLE_ERR