Dell POWEREDGE M1000E - Manual (Page 990)

962 Fabric OS Command Reference
53-1002746-01
snmpConfig
2
____________________________________________________
FA-MIB 0x1 Enabled
connUnitStatusChange(1) 0x2 Enabled
connUnitAddedTrap (2) N/A Enabled
connUnitDeletedTrap (3) 0x8 Enabled
connUnitEventTrap (4) 0x10 Enabled
connUnitSensorStatusChange(5) 0x20 Enabled
connUnitPortStatusChange (6) 0x40 Enabled
____________________________________________________
FICON-MIB 0x1 Enabled
linkRNIDDeviceRegistration (1) 0x2 Enabled
linkRNIDDevicedeRegistration(2) 0x4 Enabled
linkLIRRListenerAdded (3) 0x8 Enabled
linkLIRRListenerRemoved (4) 0x10 Enabled
linkRLIRFailureIncident (5) 0x20 Enabled
____________________________________________________
HA-MIB 0x1 Enabled
fruStatusChanged (1) 0x2 Enabled
cpStatusChanged (2) 0x4 Enabled
fruHistoryTrap (3) 0x8 Enabled
____________________________________________________
FCIP-MIB 0x1 Enabled
____________________________________________________
SCSI-MIB 0x1 Enabled
iscsiTgtLoginFailure (1) 0x2 Enabled
iscsiTgtLoginFailure (2) 0x4 Enabled
iscsiTgtLoginFailure (3) 0x8 Enabled
____________________________________________________
IF-MIB 0x1 Enabled
linkUpTrap (3) 0x8 Enabled
linkdownTrap (4) 0x10 Enabled
____________________________________________________
BBD-MIB 0x1 Enabled
bdTrap (1) 0x2 Enabled
bdClearTrap (2) 0x4 Enabled
Use the --show mibCapability option to display the traps configurable under each MIB. For more
information, refer to the Fabric OS MIB Reference.
The following MIB configuration options are supported:
--set mibCapability
Configures MIBs interactively. When used without a MIB name, this command
displays a menu with supported MIBs and associated traps, and for each MIB or
trap, you are prompted to confirm or change the default by specifying yes or no.
Specifying yes means you can access the MIB variables with an SNMP manager.
For two traps under the SW-TRAP category, the swEventTrap and the
swFabricWatchTrap, this command provides the option to specify a severity levels
to control the number of generated alerts. When a severity level is configured,
traps below the specified severity level specified are not sent. Refer to the
Examples section for an illustration. Specify one of the following values:
0
None (default)
1
Critical
2
Error