Dell POWEREDGE M1000E - Manual (Page 513)

Fabric OS Command Reference 485
53-1002746-01
ipSecConfig
2
The following operands are optional (use secCertUtil to import the key files to the
local and remote systems)
-psk file
Specifies the preshared key filename.
-pubkey file
Specifies the public key filename (in X.509 PEM format).
-privkey file
Specifies the private key filename (in X.509 PEM format).
-peerpubkey file
Specifies the peer public key filename (in X.509 PEM format).
-lttime number
Specifies the key lifetime in seconds. If a lifetime is not specified, the keys do
not expire. If a lifetime is specified both in seconds and in bytes, the keys
expire when the first expiration criterion is met.
-ltbyte number
Specifies the key lifetime in bytes. The keys expire after the specified number
of bytes have been transmitted.
-pfs on | off
Enables or disables Perfect Forward Secrecy (PFS). PFS is disabled by
default. When PFS is disabled, IKE uses the initial master key it generates in
Phase1 to generate the keys for SA connections in Phase2. When PFS is
enabled, a new key is generated for keying the SAs. Enabling PFS may
provide enhanced protection against keys compromise.
-version 1 | 2
Specifies the IKE version. This operand is optional. If not specified, IKEv2 is
used (2). If 1 is specified, IKEv1 is selected. Use -v 2 to revert to version 2
after version 1 was set.
manual-sa
Creates manually keyed SADB entries. When using this option, you must
generate the keys manually, The lifetime of an SA entry created using this
command is infinite. You cannot modify manually keyed SA entries. Use
ipsecConfig --flush, or ipsecConfig --delete and recreate the entries. The
syntax for creating an SADB entry is as follows:
ipsecconfig --add manual-sa arguments.
arguments
Valid arguments for manual-sa include the following:
-sp number
Specifies the security parameter index (SPI) for the SA. This is a user-defined
index. Valid SPI numbers consist of numeric characters (0-9).
-local ipaddress
Specifies the local IPv4 or IPv6 address.
-remote ipaddress
Specifies the remote IPv4 or IPv6 address.
-protocol protocol_name
Specifies the upper layer protocols to be selected for protection. Valid
protocols include tcp, udp, icmp or any. When any is specified all existing
protocols are selected for protection.