Dell POWEREDGE M1000E - Manual (Page 735)

Fabric OS Command Reference 707
53-1002746-01
portCfgShow
2
portCfgShow
Displays port configuration settings.
SYNOPSIS portcfgshow
portcfgshow [slot/]port
portcfgshow -i [ndex1[-index2] [...] [-f]]
portcfgshow -slot slot1[-slot2] [...]
portcfgshow option [slot/][ge_port] [arguments]
[optional_arguments]
DESCRIPTION Use this command to display the current configuration of a port. The behavior of this command is
platform-specific; output varies depending on port type and platform, and not all options are supported on
all platforms.
Non-GbE port displays
When used without operands, this command displays port configuration settings for all ports on a switch,
except Gigabit Ethernet (GbE) ports.
Displays supported only on the Brocade 7800/FX8-24
Use this command with optional arguments to display the following parameters configured for a GbE port
on the Brocade 7800/FX8-24 platforms.
•
IP interfaces on the GbE port
•
Static routes on the IP interfaces
•
Address resolution protocol (ARP) entries
•
VLAN tag configuration
•
Fibre Channel over IP (FCIP) tunnel configuration settings
•
IPSec configuration
•
Inband Management IP addresses and routes.
Non-GbE port displays
The following information is displayed when the command is issued for all ports, for a single port, or for
one or more port ranges specified by their port index numbers or slot numbers:
Area Number
Displays the port area number. This field is displayed only when portCfgShow is
executed for a single port.
Octet Speed Combo
Displays the speed configuration for a port octet. This value is set by the
portCfgOctetSpeedCombo command. Port octet speed configuration is
supported only on Condor 3-based platforms. On unsupported platforms the Octet
Speed Combo field is suppressed. Valid Octet Combo values include the
following:
1
Autonegotiated or fixed port speeds of 16 Gbps,8 Gbps,4 Gbps, and 2 Gbps.
2
Autonegotiated or fixed port speeds of 10 Gbps,8 Gbps,4 Gbps, and 2 Gbps.