Dell POWEREDGE M1000E - Manual (Page 738)

710 Fabric OS Command Reference
53-1002746-01
portCfgShow
2
Rate Limit
Displays ON when ingress rate limit is set on the port or (..) or OFF when the
ingress rate limiting feature is disabled. This value is set by the portCfgQos
--setratelimit command. The default value is OFF.
Credit Recovery
Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF
when the feature is disabled. This value is set by the portCfgCreditRecovery
command. The credit recovery feature is enabled by default, but only ports
configured as long distance ports can utilize this feature.
Port Auto Disable
Displays On when the Auto Disable feature is enabled on a port. Displays (..) or
OFF when the feature is disabled. This feature causes ports to become disabled
when they encounter an event that would cause them to reinitialize. This feature is
enabled by the portCfgAutoDisable command. The feature is disabled by
default. In the single port view, the configured trigger conditions are displayed
when the feature is disabled. Refer to the example section for an illustration.
F_Port Buffers
Displays the number of configured F_Port buffers. Displays (..) or OFF if no
buffers are configured. The buffer value is set by the portCfgfPortbuffers
command.
NPIV PP Limit
Displays the maximum number of allowed logins for the port. Displays the default
of 126 or the configured maximum. This parameter is set with the
portCfgNPIVPort --setloginlimit command.
CSCTL mode
Displays ON if CSCTL mode is enabled on the port. Displays (..) or OFF if the
feature is disabled. This parameter is set with the portCfgQos command.
D_Port mode
Displays ON when the port is configured as a D_Port; otherwise displays (..) or
OFF. Refer to the portCfgDPort command for more information. This parameter
is displayed only on on Condor3-based blades that support D_Port capability.
D-Port over DWDM
Displays ON when dwdm is enabled on that port using the portcfgdport
command. This option will be allowed to set only if the link connecting two
switches is a DWDM (Dense Wavelength Division Multiplexing) link.
Fault Delay
Displays the Fault delay value. Displays 0 if the value is R_A_TOV. This is the
default. Displays 1 if the value is 1.2 seconds. This value is set by the
portCfgFaultDelay command. valid for FC ports only.
Compression
Displays ON when compression is enabled on a port. Displays (..) or OFF when
the configuration is disabled. Compression is enabled by the portCfgCompress
command; it is disabled by default.
Encryption
Displays ON when encryption is enabled on a port. Displays (..) or OFF when the
configuration is disabled. Encryption is enabled by the portCfgEncrypt
command; it is disabled by default.
FEC
Displays ON when Forward Error Correction (FEC) is enabled on a port and the
port is online. Displays (..) or OFF when the configuration is disabled. FEC is
enabled by the portCfgFec command; it is enabled by default.