Dell POWEREDGE M1000E - Manual (Page 314)

286 Fabric OS Command Reference
53-1002746-01
faPwwn
2
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS this command has the following operands:
--enable
Enables the FA-PWWN feature on the specified switch ports or AG ports. If a
FA-PWWN is not available for the ports, this command automatically assigners
FA-PWWNs to the ports.
--disable
Disables the FA-PWWN feature on the specified switch ports or AG ports. This
commands disables the binding of any existing FA-PWWNs to the specified ports,
it does not delete the port configurations themselves. When you re-enable the
feature, the persistently saved configurations are re-applied to the ports.
--assign
Assigns a FA-PWWN to a specified port. You can specify only a single port with
this command (not a port range) and optionally provide a VPWWN. When
executed without the -v option, this command automatically generates a
FA-PWWN and assigns it to the port. When executed with the -v option, and a
user-assigned FA-PWWN already exists, this command fails with an appropriate
message. If an automatically assigned FA-PWWN exists, the user-generated
FA-PWWN overrides the automatically generated FA-PWWN. When you assign a
FA-PWWN to an AG port, you must specify the AG node WWN to uniquely identify
the AG. The new FA-PWWN will take effect upon the next login session.
--delete
Deletes the active FA-PWWN from the specified ports. If a port is bound to a
user-assigned FA-PWWN, this command deletes the currently active FA-PWWN
and activates the automatically assigned FA-PWNN. If the active FA-PWWN is
automatically assigned and no user-assigned FA-PWWN exists, this command
deletes the FA-PWWN. When deleting VPWWNs from an AG, you must specify
the AG node WWN and the -port operand is optional; if omitted, all active
FA-PWWNs are deleted from the AG. To delete a single FA-PWWN, use the
delete command with the -v option.
If no active FA-PWWNs exist on the ports, the FA-PWWN feature is disabled. Use
the -enable command to re-enable the feature.
--show
Displays the FA-PWWN configuration for the specified ports or for all ports in the
logical switch. When displaying information for AG ports, you must specify the AG
node WWN.
-port[slot/]port[-port]
Specifies the ports to be configured or displayed on the switch or on the AG,
preceded by a slot number on bladed systems. The port list can include a single
port or a port range, for example, 3-5 or 1/3-5. Port ranges are supported only with
automatically assigned FA-PWWNs, and only on switch ports. You cannot use a
port range on AG ports.
-ag AG_WWN
Specifies the Access Gateway node WWN.
-v VPWWN
Specifies a virtual PWWN to be assigned to the port. This operation deactivates
any existing FA-PWWN on the port.