Dell POWEREDGE M1000E - Manual (Page 829)

Fabric OS Command Reference 801
53-1002746-01
portShow
2
DESCRIPTION Use this command to display configuration parameters and status information for FCIP tunnels and FCIP
circuits on the GbE/10GbE ports on the Brocade 7800 and FX8-24 platforms. The FCIP tunnels on the
local and remote GbE ports act as Virtual E_Ports (VE_Ports) connecting the local and remote fabrics.
The following display options are supported on these platforms:
•
portShow fciptunnel - Displays Fibre Channel over IP (FCIP) tunnels including the following:
-
Additional performance information
-
FICON configuration parameters
-
IPSec status (enabled or disabled), mode (legacy if configured) and key
-
Circuits with the tunnel
-
QoS statistics including performance for each priority
-
FCIP Tunnel hierarchy listing circuit IDs and TCP connection information for the tunnel
•
portShow fcipcircuit - Displays status and configuration for FCIP circuits:
-
TCP statistics for the circuit
-
Circuit-level VLAN tagging configuration
-
Circuit-level Differentiated Services (DSCP) markings
•
portshow mgmtif - Displays the inband management interfaces.
•
portshow mgmtroute- Displays the routes for the inband management interfaces.
•
portShow xtun - Displays FICON and FCP emulation statistics and current runtime conditions.
OPERANDS This command has the following operands:
slot
For bladed systems only, specifies the slot number of the VE_Port to be
displayed, followed by a slash (/).
ve_port
Displays information for a single specified FCIP tunnel. On the Brocade
7800/FX8-24, specify the VE_Port number associated with the tunnel configured
on one of the GbE ports. VE_Ports are numbered 16-23 on the Brocade 7800 and
12-31 on the Brocade FX8-24 blade.
all
Displays information for all configured FCIP tunnels.
fciptunnel
Displays configuration and status per FCIP tunnel. The following operands are
supported with fciptunnel and fcipcircuit.
-c | --circuit
Displays the FCIP circuits within the tunnel. This operand can be used with any
other operand to include circuit displays.
-t | --tcp
Displays the TCP statistics for the circuit. The -c option must be specified with this
option.
--reset
Displays time based set of statistics.
--lifetime
Displays the entire lifetime statistics for FCIP Tunnels, Circuits and the
associated TCP connections. This option will ignore any time based deltas
that were created previously set using the --reset option.
-p | --perf
Displays additional performance information for the specified FCIP tunnels.