Firmwarerestore – Dell POWEREDGE M1000E User Manual
Page 415
Fabric OS Command Reference
387
53-1002746-01
firmwareRestore
2
firmwareRestore
Restores the former active firmware image.
SYNOPSIS
firmwarerestore
DESCRIPTION
Use this command to restore the former active Fabric OS firmware image. This command can only be
run if autocommit was disabled during the firmwareDownload process.
After a firmwareDownload and a reboot (with autocommit disabled), the downloaded firmware
becomes active. If you do not want to commit the firmware and want to restore the former firmware, issue
the firmwareRestore command. After running firmwareRestore, you can run firmwareDownload
again.
This command reboots the system and makes the former firmware active. After the switch reboots, both
primary and secondary partitions restore the previous firmware.
This command only takes action if the system is booted after a firmwareDownload; otherwise, the
process terminates with an error.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS
None
EXAMPLES
To restore the former active firmware image:
switch:admin> firmwarerestore
Restore old image to be active ...
Restore both primary and secondary image after reboot.
The system is going down for reboot NOW !!
Broadcast message from root (ttyS0) Fri Oct 22 23:48:54 2010...
Doing firmwarecommit now.
Please wait ...
SEE ALSO
,